Orem Quality Drywall: Residential and Commercial Drywall Installation and Repair
Orem Quality Drywall installs and repairs drywall for family homes, student rentals near Utah Valley University, and commercial suites along University Parkway and State Street. We hang, tape, mud, and texture, and we plan repair work so you can keep living in the house. You will get a written estimate after we see the walls. Typical installation work in this part of Utah County runs about $1.50 to $3.50 per square foot; small patches are quoted per job because setup and texture matching dominate the cost.
Whether you are finishing a basement off Canyon Road, turning over an apartment between UVU semesters, matching knockdown in a Scera Park remodel, or hanging Type X on a University Parkway tenant improvement, Orem Quality Drywall handles the drywall from the first measurement to the last sanding pass.
Get a Free Drywall Quote in Orem
Drywall installation and repair for Orem homes and businesses
Why Orem Homeowners and Builders Choose Orem Quality Drywall
Written Estimates After a Site Visit
Orem Quality Drywall looks at the job in person, then sends a written estimate with scope, price, and timing. Work does not start until you have that on paper.
Seamless Drywall Patches and Texture Matching
A visible patch usually means the texture was close but not the same. We match the existing pattern so the repair reads as wall, not as a repair, once it is painted.
One Drywall Crew From Hanging to Finish
One Orem Quality Drywall crew stays on the job from the first sheet through the last texture pass, so the finish is not a handoff between two companies.
Residential Drywall Services in Orem, UT
Drywall Installation
Orem Quality Drywall hangs drywall in remodels, additions, and new rooms across Orem. Panels are measured to the studs, cut for each opening, and fastened so the walls and ceilings stay flat for taping, texture, and paint.
Basement Finishing and Drywall
Plenty of Orem houses still have an unfinished lower level. Before we close those walls we look at the framing, ducts, and any damp spots on the slab, then hang, tape, and finish so the basement lines up with the living space upstairs.
Soundproof Drywall Installation
Interior walls in Orem family homes and UVU-area rentals often need more than a single layer of standard board. We can add acoustic drywall, a second layer, insulation, or isolation details, and we will describe a realistic noise reduction rather than promising a silent room.
Drywall Repair and Hole Patching
Move-out holes, bumped corners, and old thermostat cutouts are common in Orem rentals and family houses. We patch the small ones and back a new piece of board into the larger openings, then texture so the repair is ready for paint instead of sitting as a shiny blob on the wall.
Commercial Drywall Services in Orem, UT
Tenant Improvement and Office Build-Outs
We hang new office partitions, add sound control where the layout needs it, and finish ceilings to the revised plan. Patching and finish matching are part of the same visit when only part of an Orem suite is changing.
Retail and Restaurant Drywall
Retail and restaurant build-outs along State Street and University Parkway often need moisture-resistant board in kitchens and restrooms, plus coordination with fixture and signage crews. Cooking and exhaust walls follow the drawings, not a standard residential hang.
Fire-Rated and Sound-Rated Commercial Assemblies
Fire-rated and sound-rated walls are hung to the UL design or STC rating specified in the plans, using the listed board and details so the assembly matches what the inspector expects.
Commercial Drywall Repair
Cart-damaged walls, stained ceiling tile areas, and cracked corridors can usually be repaired without shutting down a whole suite. We contain dust, match the existing texture, and clean up so the space can go back into use.
Drywall Materials and Finish Levels We Use in Orem
Board Types
Orem Quality Drywall picks the board for the room: standard gypsum in most living areas, moisture-resistant board in baths and below-grade space, Type X where a fire rating is specified, and acoustic layers when a shared wall in a family house or a UVU-area rental needs more than one sheet. That choice is written into the estimate.
Finish Levels
Level 4 is the usual choice for painted walls in Orem homes and offices. Use Level 5 for smooth or glossy walls, or rooms with strong side light. Garages are often Level 2 or 3. The level is agreed up front so the hang, the paint, and the price line up.
Textures
Orem remodels often run into mixed textures from additions done years apart. We match orange peel, knockdown, and smoother patterns, and we skim coat uneven walls when you want one even surface for paint.
How Long Does a Typical Drywall Job Take?
A patch can be a short visit plus dry time. A basement or a new hang takes longer because each coat of compound has to dry, and that stretches out if an Orem basement is cold. Orem Quality Drywall puts a schedule on the written estimate so you can plan around the work.
Finishing Drywall in an Orem Winter
Yes, if the space is heated. Joint compound should stay at about 50°F or warmer until it dries. Turn the heat on in a new build or a basement before we finish, especially during a Utah Valley inversion when nights stay cold.
Scheduling Around Occupied Homes and Semester Turnovers
Most repairs and one-room remodels can be done while you stay in the house, including occupied rentals near Utah Valley University. That room will be closed off. Whole-house hangs mean arranging to be out of those rooms. We can also time rental work between semesters when units are empty.
Orem Quality Drywall's 5-Step Drywall Process
01 Free Estimate and Site Visit
Someone from Orem Quality Drywall looks at the walls with you, confirms the scope, and writes an estimate covering price and schedule.
02 Protect the Space and Prep the Work Area
We cover floors, set up dust control, and check framing and moisture before hanging any new board.
03 Drywall Hanging
Panels are hung on walls and ceilings using the board specified for that room, not a single type for the whole house.
04 Taping, Mudding, Sanding and Texture
We tape and mud the joints, sand, and apply texture so it lines up with the existing walls or with the finish you picked for a new room.
05 Final Inspection and Cleanup
After a final look at the finish, we complete touch-ups and leave the space clean and ready to paint.
Drywall Services in Orem, UT and Nearby Areas
Orem Quality Drywall serves homeowners, renters, builders, and businesses in Orem and nearby cities, including Provo, Lindon, Pleasant Grove, American Fork, and Vineyard.
Orem, UT: Drywall hanging, finishing, and repair across Orem, including homes around Scera Park, rentals near UVU, and commercial suites on University Parkway and State Street.
Provo: Immediately south of Orem: residential repairs, campus-area rentals, and downtown or University Avenue commercial work in Provo.
Lindon and Pleasant Grove: North of Orem: remodel, texture matching, and repair work in Lindon and Pleasant Grove.
American Fork and Vineyard: Northwest and west of Orem: residential and light commercial work in American Fork, and new-home hanging and finishing in Vineyard.
Orem, UT
Provo, Lindon, Pleasant Grove, American Fork, and Vineyard
Orem shares the Utah Valley's dry air and winter inversions with the rest of the county. Indoor humidity drops hard when the heat runs, and joint compound that dries too fast, or is applied in a cold garage, is more likely to shrink and crack. Keep finished rooms at about 50°F or warmer until the mud has dried, especially on new builds and basement finishes started in January.
Orem's housing is a mix: established mid-century neighborhoods around Scera Park and the older State Street grid, student rentals near Utah Valley University that turn over between semesters, commercial suites on University Parkway, and a large amount of newer construction immediately west in Vineyard. Those jobs do not use the same board or the same schedule. Orem Quality Drywall hangs and finishes in all of them, and we plan texture matching and dust control differently in an occupied rental than on an empty new-home lot.
Drywall in Orem's Dry Climate, Inversions, and Mixed Housing
Orem, UT
Ready for Drywall Work in Orem? Talk to Orem Quality Drywall
Describe the rooms to Orem Quality Drywall. We will come look at the walls and send a written estimate before a sheet of board goes up.
Drywall FAQs for Orem Homeowners, Builders and Businesses
Orem Quality Drywall installs and repairs drywall, including taping, texture, popcorn removal (after testing when needed), garage and fire-separation walls, sound-control assemblies, metal-stud framing, and commercial drop ceilings.
In Orem, small patches are usually priced per job. Larger replacement typically runs $2.00 to $6.00 per square foot, and new installation $1.50 to $3.50 per square foot, depending on size, board, and finish. The written estimate comes after a site visit.
Yes. We match the texture already on the wall — including mixed patterns from older Orem additions — so the repair is ready for paint rather than obvious as a patch.
A patch can be a short visit plus dry time. A basement or new hang takes longer because each coat has to dry, and that stretches out if an Orem basement is cold. Your estimate will include a schedule.
Floors are covered, the work area is contained, and we clean up before we leave. Sanding still makes dust; we keep it from spreading through the rest of the house.
Yes for most repairs and one-room remodels, including occupied rentals near UVU. You will hear the work, and that room will be closed off. A whole-house hang usually means arranging to be out of those rooms.
Patches are fine for holes and most cracks. Soft board from a leak, or a large broken section, should be replaced. We will recommend one or the other after seeing the damage.
Yes. Orem Quality Drywall bids new homes, Vineyard and Orem additions, basement finishes, and commercial build-outs from plans, with labor and material broken out on request.
Level 4 is the usual choice for painted walls in Orem homes and offices. Use Level 5 for smooth or glossy walls, or rooms with strong side light. Garages are often Level 2 or 3.
Yes, if the space is heated. Joint compound should stay at about 50°F or warmer until it dries. Turn the heat on in a new build or a basement before we finish, especially during a valley inversion.
Yes. Some older Orem houses still have popcorn. Texture from before the mid-1980s may contain asbestos and should be tested before anyone scrapes it. After a clear test, we remove it and refinish the ceiling smooth or in a new texture.